Drawing Simple Shapes
move forward
when run
move forward
turn right on
120°...
Engineering, 21.02.2021 22:20 10040813
Drawing Simple Shapes
move forward
when run
move forward
turn right on
120°
turn
right
120°
turn
left o
120°
Z
Answers: 3
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
English, 01.10.2019 08:00
Computers and Technology, 01.10.2019 08:00
English, 01.10.2019 08:00
Mathematics, 01.10.2019 08:00
Mathematics, 01.10.2019 08:00
Physics, 01.10.2019 08:00
English, 01.10.2019 08:00
Mathematics, 01.10.2019 08:00
Mathematics, 01.10.2019 08:00
Physics, 01.10.2019 08:00
History, 01.10.2019 08:00