Engineering, 24.02.2020 18:01 jesussanchez1445

The wind chill, which is experienced on a cold, windy day, is related to increased heat transfer from exposed human skin tothe surrounding atmosphere. Consider a layer of fatty tissuethat is 3 mm thick and whose interior surface is maintained at atemperature of 36ºC. On a calm day the convection heattransfer coefficient at the outer surface is 25W/(m2•K), but with 30km/h winds it reaches 65W/(m2•K). In both cases the ambient airtemperature is -15ºC. k value for fatty tissue is 0.2W/mK.
(a) What is the ratio of the heat loss perunit area from the skin for the calm day to that for the wil
(b) What will be the skin outer surfacetemperature for the calm day? For the windy day?
(c) What temperature would the air have toassume on the calm day to produce the same heat loss

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t

Answers: 3

Answer

Engineering, 04.07.2019 19:10

The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)

Answers: 3

Answer

You know the right answer?

The wind chill, which is experienced on a cold, windy day, is related to increased heat transfer fro...

Questions