subject
Engineering, 24.02.2020 18:00 ashiteru123

Two small disks A and B of mass 3 kg and 1.5 kg, respectively, may slide on a horizontal, frictionless surface. They are connected by a cord, 600 mm long, and spin counterclockwise about their mass center G at the rate of 10 rad/s. At t = 0, the coordinates of G are x0¯¯¯¯¯=0, y0¯¯¯¯¯=2m, and its velocity v¯¯¯0=(1.2m/s)i+(0.96m/s)j. Shortly thereafter the cord breaks; disk A is then observed to move along a path parallel to the y axis, and disk B moves along a path that intersects the x axis at a distance b = 7.5 m from O. Determine
(a) the velocities of A and Bafter the cord breaks,
(b) the distance a from the y axis to the path of A.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.
Answers: 1
question
Engineering, 04.07.2019 18:10
Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa
Answers: 1
question
Engineering, 06.07.2019 04:10
Natural gas (95 percent methane and 5 percent ethane by volume) flows through a 90 cm diameter pipeline with a velocity of 3 m/s. the pressure in the pipeline is 700 kpa, and the temperature is 15°c. calculate: (a) the mass and volumetric flow rates in this pipe.
Answers: 1
question
Engineering, 06.07.2019 04:10
An array of m-50 thermoelectric modules is installed on the exhaust of a sports car. each module has an effective seebeck coefficient of sp of 0.143 5vk and an internal electrical resistance of r.-4 ? in addition, : (15 points each module is of width w 60mm and contains n=100 pairs of semiconducting pellets. each pellet hasan overall length of 2l-5mm and a cross-sectional area as 1.2 x 10'm and is characterized by a thermal conductivity of kpl2w rnk. the hot side of each module is exposed to exhaust gases at·p650c with hia4ow rrk while the osite side of each module is cooled by pressurized water at surface) and 156 °c (at the cool surface). 11s c with h: -500w/m'k. the modules are wired n series and the load resistance is r d=400ohm .the module surface temperatures, t, and ts are 183 "c (at the hot surface and 156c (at the cool surface) a)-draw a schematic of this scenario and label all parts. a. b. if the induced current, i, is 0.15 amps, what is the total power (pa) for one module? c. what is the total power harvest from the exhaust with all 50 modules?
Answers: 2
You know the right answer?
Two small disks A and B of mass 3 kg and 1.5 kg, respectively, may slide on a horizontal, frictionle...
Questions
question
English, 01.12.2019 12:31
question
Mathematics, 01.12.2019 12:31