In a resistance experiment, a gold ring was connected into a circuit as a resistor. The connections touched on diametrically opposite points on the circular ring. Its diameter is 2 cm, and the metal's cross-section is a rectangle 3 mm by 0.5 mm. A voltmeter connected across the ring measured 4.2 mV, whilst the current through it was measured at 18 A. gold ring V A fig E:

Acar travels along a highway with a velocity of 24 m/s, west. the car exits the highway; and 4.0 s later, its instantaneous velocity is 16 m/s, 45° north of west. what is the magnitude of the average acceleration of the car during the four-second interval?

Fft review: linspace, fs, fftshift, nfft 1. generate one second of a cosine of w,-10hz sampled at f, = 100hz and assign it to x. define a tt as your time axis 2. take 64 points fft. 3. as you remember, the dft (which the fft implements) computes n samples of s2t where k-0,1,2, n -1. plot the magnitude of this 64-points fft at range 0 to 63, what do you think of this graph? 4â·to get the x-axis into a hz-frequency form, plot this 64-points fft between-50 to 50 (the 100hz sampling rate) and have n-points between them. 5. according to your figure, what frequency is this cosine wave at? 6. remember that the fft is evaluating from 0 to 2ď€. we are used to viewing graphs from-ď€ to ď€. therefore, you need to shift your graph. 7. now according to your shifted graph. what frequency is this at? 8. note that the spikes have long drop-offs? try a 1024-point dft. note that the peak is closer to 10 and the drop-off is quicker. although, now sidelobes are an issue

An inclined plane wrapped around a metal shaft is a a. lever b. screw c. pulley d. wedge