When an object speeds up , it gains momentum

Ok i am attempting to my niece attach a galvanized wire (like a tether for a dog) at the corner of two fences, making a tightwire if you will and we drilled a hole in a softball and she hits it. the ? and problem is that we can not get the wire taunt enough where it doesnt sag after hitting the ball once, and the wire sags and wobbbles. its a 15 ft rubber covered galvanized wire and one can adjust the length of the placing of the wire by having it make the corner of 2 fences become a it can be adjusted, however, with all our human strength and pliers we could not make it taunt as possible. is there anything other that attaching it to a car to do this. sorry abt the length but it would mean the world to my niece if i could solve this came up with the entire idea herself, and she is 14 and paid for the wire and did as much work as i did drilling a hole through a softball wide enough for attaching piece at each end of the wire that clips on to the fence. . any ideas welcome if serious. but awesome if it is a fact. much obliged. bucky bukowski buckman

Part f - example: finding two forces (part i) two dimensional dynamics often involves solving for two unknown quantities in two separate equations describing the total force. the block in (figure 1) has a mass m=10kg and is being pulled by a force f on a table with coefficient of static friction îľs=0.3. four forces act on it: the applied force f (directed î¸=30â above the horizontal). the force of gravity fg=mg (directly down, where g=9.8m/s2). the normal force n (directly up). the force of static friction fs (directly left, opposing any potential motion). if we want to find the size of the force necessary to just barely overcome static friction (in which case fs=îľsn), we use the condition that the sum of the forces in both directions must be 0. using some basic trigonometry, we can write this condition out for the forces in both the horizontal and vertical directions, respectively, as: fcosî¸â’îľsn=0 fsinî¸+nâ’mg=0 in order to find the magnitude of force f, we have to solve a system of two equations with both f and the normal force n unknown. use the methods we have learned to find an expression for f in terms of m, g, î¸, and îľs (no n).

In a heat engine if 1000 j of heat enters the system the piston does 500 j of work, what is the final internal energy of the system if the initial energy was 2000 j? 1. write the equation 2.list out your known variables 3.plug the numbers into the equations 4.solve 5.write your solution statement that includes initial energy and final