subject
Physics, 19.03.2020 21:38 leannamat2106

If a power utility were able to replace an existing 500 kV transmission line with one operating at 1 MV, it would change the amount of heat produced in the transmission line to .

a. none of these.
b. The amount of heat produced would remain the same.
c. one-fourth of the previous value.
d. two times the previous value.
e. one-half of the previous value.
f. four times the previous value.

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 22:00
What type of light does this light bulb produce most (i.e. at what wavelength does the spectrum have maximum intensity)?
Answers: 3
question
Physics, 22.06.2019 06:20
Atwo-stage air compressor operates at steady state, compression 10m^3/min of air from 100 kpa and 300k to 1200 kpa. an intercooler between the two stages cools the air to 300k at a constant pressure of 350 kpa. the compression processes are isentropic. a) calculate the power required to run the compressor, in kw b) compare the result to the power required for isentropic compression from the same inlet state to the same final pressure.
Answers: 1
question
Physics, 22.06.2019 11:20
The ultracentrifuge is an important tool for separating and analyzing proteins. because of the enormous centripetal accelerations, the centrifuge must be carefully balanced, with each sample matched by a sample of identical mass on the opposite side. any difference in the masses of opposing samples creates a net force on the shaft of the rotor, potentially leading to a catastrophic failure of the apparatus. suppose a scientist makes a slight error in sample preparation and one sample has a mass 10 mg larger than the opposing sample. if the samples are 12 cm from the axis of the rotor and the ultracentrifuge spins at 70,000 rpm, what is the magnitude of the net force on the rotor due to the unbalanced samples? ( be thorough on your answer)
Answers: 3
question
Physics, 22.06.2019 12:20
Which of the following situations is impossible? a) an object has velocity directed east and acceleration directed east. b) an object has zero velocity but non-zero acceleration. c) an object has constant non-zero velocity and changing acceleration. d) an object has velocity directed east and acceleration directed west. e) an object has constant non-zero acceleration and changing velocity.
Answers: 2
You know the right answer?
If a power utility were able to replace an existing 500 kV transmission line with one operating at 1...
Questions
question
Mathematics, 18.06.2021 20:10
question
Mathematics, 18.06.2021 20:10
question
Mathematics, 18.06.2021 20:10
question
Biology, 18.06.2021 20:10
question
Mathematics, 18.06.2021 20:10
question
Mathematics, 18.06.2021 20:10