Physics, 22.11.2019 05:31 rjone8429

When 2.00 kj of energy is transferred as heat to nitrogen in a cylinder fitted with a piston with an external pressure of 2.00 atm, the nitrogen gas expands from 2.00 to 5.00 l. what is the change in internal energy of this system? (1 l·atm = 0.1013 kj)

Answers: 3

Show answers

Another question on Physics

Physics, 22.06.2019 19:50

The heater element of a 120 v toaster is a 5.4 m length of nichrome wire, whose diameter is 0.48 mm. the resistivity of nichrome at the operating temperature of the toaster is 1.3 × 10-6 ω·m. the toaster is operated at a voltage of 120 v. (a) what is the power drawn by the toaster? (b) if the cost of electricity is 12 ¢ per kilowatt-hour, and it takes 2 minutes to toast bread, how much does it cost for toasted bread? (c) when the heater element is at room temperature, is the resistivity in the nichrome wire greater than, less than, or equal to it’s resistivity when at operating temperature? explain.

Answers: 3

Answer

Physics, 23.06.2019 01:00

Two solutions of the same uv-absorbing molecule were analyzed by uv-vis spectroscopy on the same instrument using 1 cm pathlength cells. use data from the table to calculate by what percentage the concentration of solution b is compared to that of solution a.sample absorbance at 315nm a 0.45 b 0.80

Answers: 1

Answer

Physics, 23.06.2019 08:00

Athin electrical heater is inserted between a long circular rod and a concentric tube with inner and outer radii of 20 and 40 mm. the rod (a) has a thermal conductivity of ka = 0.15 w/(m*k), while the tube (b) has a thermal conductivity of kb = 0.8 w/(m*k) and its outer surface is subjected to convection with a fluid of temperature t= -15°c and heat transfer coefficient 60 w/(m2 *k). the thermal contact resistance between the cylinder surfaces and the heater is negligible. (a) determine the electrical power per unit length of the cylinders (w/m) that is required to maintain the outer surface of cylinder b at 15°c. (b) what is the temperature at the center of cylinder a?

Answers: 2

Answer

Physics, 23.06.2019 10:00

The pressure in car tires is often measured in pounds per square inch (lb/in.2), with the recommended pressure being in the range of 25 to 45 lb/in.2. suppose a tire has a pressure of 27.5 lb/in.2 . convert 27.5 lb/in.2 to its equivalent in atmospheres.

Answers: 1

Answer

You know the right answer?

When 2.00 kj of energy is transferred as heat to nitrogen in a cylinder fitted with a piston with an...

Questions