Abox is sliding with a speed of 4.50 m/s on a horizontal surface when, at point p, it encounters a rough section. on the rough section, the coefficient of friction is not constant but starts at .100 at p and increases linerly with distance past p, reaching a value of .600 at 12.5 m past point p. (a) use the work energy theorem to find how far this box slides before stopping. (b) what is the coefficient of friction at the stopping point? (c) how far would the box have slid iff the friciton coefficient didn't increase, but instead had the constant value of .1?

A110-pound person pulls herself up 4.0 feet. this took her 2.5 seconds. how much power was developed? 0.13 hp 0.32 hp 2.0 hp 3.1 hp

Idon’t quite understand this problem

5submission this assignment is worth 20 points total. you are required to submit the following by next lab: 1. (3 points) determine the equation for the output angular velocity ω2 = θ˙ 2 as a function of θ1, ω1 = θ˙ 1 and α. you must show all your work to receive credit. 2. (2 points) use the result of problem#1 to plot ω2 over 0 ≤ θ1 ≤ 360deg with ω1 = 360deg/sec. do this for α = {10,30}deg. show the results on the same plot and properly label the axes, title, legend. for this you can use matlab or ms excel. 3. (3 points) determine the equation for the output angular acceleration ω˙ 2 and create a plot similar to the one in problem#2. 4. (10 points) submit plots of the results (ω2 and ω˙ 2) obtained from creo/mechanism and compare them to results of problem#2 and problem#3. note that you should do these comparisons for the two cases with α = {10,30}deg. 5. (2 points) provide a brief explanation of the results. did they match? what are the implications as misalignment angle increases?