Two cars leave towns 480 kilometers apart at the same time and travel toward each other. one car's rate is 20 kilometers per hour less than the other's. if they meet in 3 hours, what is the rate of the slower car

70 km/h

Explanation:

Let the velocity of car A is v km/h, thus the velocity of car B is (v - 20) km/h.

They meet after 3 hours.

Distance traveled by car A in 3 hours = v x 3 = 3 v

Distance traveled by car B in 3 hours = (v - 20) x 3 = 3v - 60

Total distance traveled is 480 km

So, 3 v + 3 v - 60 = 480

6 v - 60 = 480

6 v = 540

v = 90 km/h

Thus, the speed of car A is 90 km/h and the speed of car B is 90 - 20 = 70 km/h.

i need my girl back keith uses i need my girl back

explanation:

my daughter rae

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).