subject
Engineering, 13.12.2021 22:10 kashishmehta917

Several middle school students want to build 30 solar eclipse projectors for children at an elementary school to use. The projectors make it easy and safe for people to view a solar eclipse. One possible design of a student-constructed solar eclipse projector is shown below. Image courtesy of NASA

Which of the following would be the most reasonable criterion the students should consider before building the projectors?
A.
It should be small enough to fit in a school backpack.
B.
It should be made of heavy enough materials so that it cannot easily be moved.
C.
It should be durable enough so that if it is dropped, it will not break.
D.
It should be made mostly of metal materials.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
question
Engineering, 04.07.2019 19:10
What is a monomer? how do they form a ploymer from the view point of chemical bonding?
Answers: 1
You know the right answer?
Several middle school students want to build 30 solar eclipse projectors for children at an elementa...
Questions
question
Computers and Technology, 24.09.2019 01:30
question
Geography, 24.09.2019 01:30