Engineering, 15.05.2021 01:00 royal6032
A 2x6 (1.5 inch by 5.5 inch) edgewise beam is used to carry the load specified above. The beam has 3 inches of bearing length at each end support. The bending strength is 2500 psi, shear strength is 170 psi, the modulus of elasticity is 1.5x106 psi, deflection limit is L/240 and the compression perpendicular to grain is 600 psi. Find the following values to design the beam;
a. The maximum shear force
b. The maximum moment
c. The value of the deflection limit
d. The bending stress in the beam
e. The shear stress in the beam
f. The maximum deflection in the beam
g. The maximum bearing stress at the support
h. Does the beam fail?
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
Engineering, 04.07.2019 19:10
Asteel wire of 2 mm diameter is fixed between two points located 2 m apart. the tensile force in the wire is 250n, if its density of steel is given by 7830 kg/m3 the fundamental frequency of vibration hz? ?
Answers: 3
Engineering, 04.07.2019 19:20
At steady state, air at 200 kpa, 325 k, and mass flow rate of 0.5 kg/s enters an insulated duct having differing inlet and exit cross-sectional areas. the inlet cross-sectional area is 6 cm2. at the duct exit, the pressure of the air is 100 kpa and the velocity is 250 m/s. neglecting potential energy effects and modeling air as an 1.008 kj/kg k, determine ideal gas with constant cp = (a) the velocity of the air at the inlet, in m/s. (b) the temperature of the air at the exit, in k. (c) the exit cross-sectional area, in cm2
Answers: 2
You know the right answer?
A 2x6 (1.5 inch by 5.5 inch) edgewise beam is used to carry the load specified above. The beam has 3...
Questions
History, 22.04.2020 21:23
Mathematics, 22.04.2020 21:23
Mathematics, 22.04.2020 21:24
Mathematics, 22.04.2020 21:24
Physics, 22.04.2020 21:24
