Three (3) Types of Section Views used in engineering drawing are
Plan, Front and End
O...
Engineering, 22.04.2021 17:40 jasmindelvalle78
Three (3) Types of Section Views used in engineering drawing are
Plan, Front and End
Orthographic, Isometric and Oblique Section
Full, Half and Offset Section
None of the above
Answers: 3
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.
Answers: 2
Engineering, 04.07.2019 18:20
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
Mathematics, 25.01.2020 00:31
English, 25.01.2020 00:31
English, 25.01.2020 00:31
Chemistry, 25.01.2020 00:31
Mathematics, 25.01.2020 00:31
Mathematics, 25.01.2020 00:31
Biology, 25.01.2020 00:31