Engineering, 02.04.2021 15:30 ely093

An inventor lives near a mountain that in the summertime has a temprature of 40 degrees farenheit at the top. A tubing line could be run in a loop from the base of the mountain to the top. It would be insulated the entire length, except at the top of the mountain and at the base, where appropriate equipment connects to the loop in order to drive a heat engine. The average temprature at the base of the mountain during summer is 100 degrees farenheit 10lbs/s if R-134a flows through the system. At the base of the mountains, ambient air transfers heat to the refrigerant, and takes it from 40 degress farenheit sub-cooled liquid to 100 degree farenheit at 100 psia. Find:1. Computer the maximum theoretical efficiency of any heat engine operated netween the two temprature2. Compute the rate of heat input to the enginge3. Compute the maximum theoretical power output of the engine (hp)

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 19:30

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

You know the right answer?

An inventor lives near a mountain that in the summertime has a temprature of 40 degrees farenheit at...

Questions