Engineering, 25.03.2021 19:30 sclifton2014
A shaft and hole have a nominal diameter of 1 in. The shaft has a tolerance of 0.003in, the hole has a tolerance of 0.004in and the allowance is set at 0.001in. The dimensions are based on the Basic Hole System. Show the deviations for the shaft and the hole from nominal size; calculate the maximum and minimum clearance for two mating parts.
Answers: 2
Engineering, 04.07.2019 18:10
Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.
Answers: 2
Engineering, 04.07.2019 18:20
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
Engineering, 04.07.2019 18:20
Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.
Answers: 2
Engineering, 04.07.2019 19:10
What is the main objective of using reheat rankine cycle?
Answers: 3
A shaft and hole have a nominal diameter of 1 in. The shaft has a tolerance of 0.003in, the hole has...
Mathematics, 24.09.2020 21:01
Social Studies, 24.09.2020 21:01
Mathematics, 24.09.2020 21:01
Mathematics, 24.09.2020 21:01
English, 24.09.2020 21:01
Computers and Technology, 24.09.2020 21:01
Mathematics, 24.09.2020 21:01
Mathematics, 24.09.2020 21:01
Mathematics, 24.09.2020 21:01
Mathematics, 24.09.2020 21:01
Business, 24.09.2020 21:01