![subject](/tpl/images/cats/User.png)
Engineering, 01.03.2021 22:00 naomicervero
A commercial steel supplier lists rectangular steel tubing having outside dimensions of 4 inch by 2 inch and a wall thickness of 0.109 in. Compute the maximum torque that can be applied to such a tube if the shear stress is to be limited to 6000 psi. For this torque, compute the angle of twist of the tube over a length of 6.5 ft.
![ansver](/tpl/images/cats/User.png)
Answers: 2
![](/tpl/images/ask_question.png)
![](/tpl/images/ask_question_mob.png)
Another question on Engineering
![question](/tpl/images/cats/User.png)
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
![question](/tpl/images/cats/User.png)
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
![question](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
![question](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
You know the right answer?
A commercial steel supplier lists rectangular steel tubing having outside dimensions of 4 inch by 2...
Questions
![question](/tpl/images/cats/geografiya.png)
Geography, 09.09.2020 21:01
![question](/tpl/images/cats/istoriya.png)
![question](/tpl/images/cats/health.png)
Medicine, 09.09.2020 21:01
![question](/tpl/images/cats/mat.png)
Mathematics, 09.09.2020 21:01
![question](/tpl/images/cats/fizika.png)
![question](/tpl/images/cats/himiya.png)
![question](/tpl/images/cats/ekonomika.png)
![question](/tpl/images/cats/himiya.png)
![question](/tpl/images/cats/en.png)
English, 09.09.2020 21:01
![question](/tpl/images/cats/mat.png)
Mathematics, 09.09.2020 21:01
![question](/tpl/images/cats/mat.png)
Mathematics, 09.09.2020 21:01
![question](/tpl/images/cats/mat.png)
![question](/tpl/images/cats/biologiya.png)
Biology, 09.09.2020 21:01
![question](/tpl/images/cats/en.png)
English, 09.09.2020 21:01
![question](/tpl/images/cats/istoriya.png)
History, 09.09.2020 21:01
![question](/tpl/images/cats/User.png)
![question](/tpl/images/cats/health.png)
Health, 09.09.2020 21:01
![question](/tpl/images/cats/geografiya.png)
Geography, 09.09.2020 21:01
![question](/tpl/images/cats/obshestvoznanie.png)
Social Studies, 09.09.2020 21:01