subject
Engineering, 15.02.2021 20:00 raeesahp6693

Consider an unconfined aquifer that is isotropic and homogenous. It has a hydraulic conductivity of 0.0018cm/s and an effective porosity of 0.25. The aquifer is in a bed of sand with auniform thickness of 40m. A small town is built on top of this aquifer. Two channelsthat are 300m apart border the aquifer. The channel on the left sidehas a depth to water that is7.8m below the land surface, while the channelon the right side has a depth to water that is 10.5 m from the surface. a. Plot the water table profile of this system assuming water in the aquifer only comes from the channels and there is no net loss/gain from evaporation/infiltration b. Determine the minimum infiltration rate at which the land surface will begin saturating, and provide the location between the channels where surface saturation first occurs. This information is critical to reinforce buildings in the town that could experience liquefaction c. The infiltration rate after a heavy storm is 6E-07 m/s. Determine if land saturation is expected to occur, and if so, the span of land that could be surface saturated d. Imagine that the storm has continued for days. As consultant, you might recommend pumping water out of one of the two channels to restore a safe depth to water-table that is at least 4m below the land surface. Which channel would be best to pump water out of and how low would you require the water to be in the channel to achieve this safety measure?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
question
Engineering, 04.07.2019 18:10
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
You know the right answer?
Consider an unconfined aquifer that is isotropic and homogenous. It has a hydraulic conductivity of...
Questions
question
Social Studies, 06.05.2021 05:50
question
Mathematics, 06.05.2021 05:50
question
Mathematics, 06.05.2021 05:50
question
Mathematics, 06.05.2021 05:50
question
Mathematics, 06.05.2021 05:50
question
Biology, 06.05.2021 05:50
question
Social Studies, 06.05.2021 05:50
question
English, 06.05.2021 05:50