Engineering, 16.10.2020 23:01 whitewesley124

Pls, Help. This is for Engineering Science Procedure
You will design and create a simulated electrical energy distribution system. Successful system design will demonstrate strategic power distribution to meet the demand of residential consumers.
The resistor simulates losses in energy due to transferring energy from the power plant to the residential consumers.
Each LED represents one household in the city. Design a circuit to provide power to the maximum number of households.

Design Constraints
The battery must be connected in series with the resistor in the circuit followed by the LEDs in any configuration you determine to be the most desirable.
Check with your teacher for the amount of time allowed (always remember the time constraint even if not listed).
Do on TinkerCAD

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

Answer

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?

Answers: 1

Answer

Engineering, 04.07.2019 19:10

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

Answer

You know the right answer?

Pls, Help. This is for Engineering Science Procedure
You will design and create a simulated e...

Questions