subject
Engineering, 22.09.2020 18:01 brendaesme

The substance called olivine may have any composition between Mg2SiO4 and Fe2SiO4, i. e. the Mg atoms can be replaced by Fe atoms in any proportion without altering the crystal structure except by expanding it slightly: this is an example of a binary solid solution series. For different compositions, the lines in the powder diffraction patterns are in slightly different positions, because of the cell expansion, but the overall pattern remains basically the same. The spacing of the lattice planes varies linearly with composition, and this can be used in a rapid and non- destructive method of analysis. a. The (062) reflection from olivine is strong and well resolved from other lines. Calculate d062 for an olivine that displays its (062) reflection at a Bragg angle of 37.21° (i. e., a diffraction angle of 74.42°) when x-rays with a wavelength of 0.1790 nm are used. b. The d062 spacing as measured accurately for synthetic materials is 0.14774 nm for Mg2SiO4 and 0.15153 nm for Fe2SiO4. What would be the approximate composition, expressed in mol.% Mg2SiO4, of an olivine material for which do62 has the value obtained in part 2.1 above?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation
Answers: 1
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 18:20
Inadequate stores control is not an obstacle to effective work order system. (clo4) a)-true b)-false
Answers: 3
You know the right answer?
The substance called olivine may have any composition between Mg2SiO4 and Fe2SiO4, i. e. the Mg atom...
Questions
question
Mathematics, 20.10.2019 14:50
question
Mathematics, 20.10.2019 14:50