subject
Engineering, 28.07.2020 20:01 arivalen

Determine if each of the following statements is true or false 1 Larger atoms are better nucleophiles due to polarizability.
2 The identity of the nucleophile affects the rate of an SN1 reaction.
3 SN2 reactions proceed via frontside attack.
4 Bimolecular reactions tend to be stereoselective.
5 SN2 reactions invert all stereocenters in a haloalkane.
6 Cl-, OH-, and H- are good all leaving groups.
7 Good bases tend to be good nucleophiles
8 Branching adjacent to a reacting carbon slows SN2 reactions due to steric hindrance.
9 SN1 reactions are slowed by hyperconjugation of the carbocation intermediate.
10 The rate determining step for SN1 reactions is the same as the rate determining step for E1 reactions.
11 It is possible to get E1 alone but SN1 is always accompanied by E1.
12 Leaving group ability depends only on pKa of the conjugate acid.
13 Good nuclephiles are also good leaving groups.
14 Protic solvents solvate large ions better than small ions because of increased surface area.
15 Steric hindrance is a major factor in determining between SN2 and E2 mechanisms.
16 Backside attack always converts R to S and vice versa.
17 Nucleophile ability is solely dependent on the pka of the conjugate acid.
18 A high concentration of good nucleophile will increase the ratio of SN1 product to E1 product

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
question
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
question
Engineering, 04.07.2019 19:10
The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false
Answers: 2
question
Engineering, 04.07.2019 19:10
Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.
Answers: 1
You know the right answer?
Determine if each of the following statements is true or false 1 Larger atoms are better nucleophil...
Questions
question
Mathematics, 19.09.2019 18:30
question
Mathematics, 19.09.2019 18:30