Engineering, 19.06.2020 05:57 serenityburke

Hogden is conducting an experiment to determine how much force it takes for a nail to puncture a tire, causing a flat. He uses five identical nails and tests them on five identical tires filled with equal amounts of air. He hits each nail one time, applying a different force each time. His results are recorded below. Trial Force (lbs) Result nail 1 15.0 no flat nail 2 30.0 no flat nail 3 45.0 no flat nail 4 60.0 flat nail 5 75.0 flat What can Hogden conclude from his results? A. It takes exactly 60.0 pounds of force on the nail to cause a flat. B. It takes exactly 45.0 pounds of force on the nail to cause a flat. C. It takes between 60.0 and 75.0 pounds of force on the nail to cause a flat. D. It takes between 45.0 and 60.0 pounds of force on the nail to cause a flat.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

Answer

You know the right answer?

Hogden is conducting an experiment to determine how much force it takes for a nail to puncture a tir...

Questions