Engineering, 02.06.2020 15:57 lilquongohard

A circular rod is attached to a wall. It has three gears (1, 2, 3).
Gear 1 is located D inches away from the wall.
Gear 2 is E inches away from Gear A.
Gear 3 is A + B inches away from Gear B.
The torque applied to Gear 1 is A kip-ft, Gear 2 is B kip-ft, Gear 3 is C kip-ft.
If the value of A, B,C is even the torque is positive, if odd the torque is negative.
The outdoor diameter is your largest number in centimeters. The inner diameter is your smallest number in centimeter. Make sure to convert to appropriate units.
The rod is made from Red Brass C83400 from the wall to Gear 1, Structural A-36 Steel from Gear 1 to Gear 2, and Magnesium Alloy Am 1004-T61 from Gear 2 to Gear 3.
a. Draw your diagram with clearly labeled distances, torques, etc.
b. Calculate the maximum shear stress for the three different materials.
c. How many degrees and in which direction does gear three turn in relation to the wall when all three torques are applied?

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

Answer

Engineering, 06.07.2019 03:10

Two slings are used to lift a girder of length l and uniform weight per unit length. what is the best position for the slings if the bending moment due to the weight of the girder is to be kept to a minimum?

Answers: 2

Answer

You know the right answer?

A circular rod is attached to a wall. It has three gears (1, 2, 3).
Gear 1 is located D inche...

Questions