subject
Engineering, 02.06.2020 14:57 xxaurorabluexx

Aiuda porfavor
¿Cuál es la ecuación para el cálculo de sistemas de ruedas dentadas?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
question
Engineering, 04.07.2019 19:20
To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.
Answers: 1
question
Engineering, 06.07.2019 05:10
Asteam turbine is supplied with steam at 28bar and 425c. a fraction of the steam is extracted at 1.2bar to heat the feed water in one open feed water heater. the rest of the steam expands in the low pressure stage of the turbine to 0.08bar. a)-sketch the regenerative rankine cycle with open feed water heater on the t-s diagram. b)-assuming isentropic expansion in both stages of the turbine, find the cycle efficiency. do not assume negligible pump work.
Answers: 1
question
Engineering, 06.07.2019 05:20
Acantilever of 3 m length with a t-shaped cross-section is loaded by three concentrated loads: w,-80 n at the free end, w 30 n, and w,-60 n at a distance of 1 m from the free end. all loads are applied at the outer edges of the flange as indicated in the sketch below. (a)-determine the maximum torsional shear stresses in the flange and in the web at distances 0.5 m and 2.5 m from the free end (sections i and ii marked in the sketch) b)- determine thefh end cross section assuming a shear modulus of 210 gpa.
Answers: 3
You know the right answer?
Aiuda porfavor
¿Cuál es la ecuación para el cálculo de sistemas de ruedas dentadas?...
Questions