Engineering, 24.04.2020 16:03 tonnie179

A part is loaded with a combination of bending, axial and torsion such that the following stresses are created at a particular location:
Bending: Completely reversed with a maximum stress of 41MPa.
Axial: Constant stress of 18 MPa.
Torsion: Repeated load, varying from 0 MPa to 55 MPa.
Assume the varying stresses are in phase with each other. The part contains a notch such that Kf, bending = 1.3, Kf, axiel =1.1, and Kf, torsion = 2.0. The material properties are Sy = 300 MPa and Su = 400 MPa. The completely adjusted endurance limit is found to be Se = 200 MPa.
1. Using the Goodman criterion, find the factor of safety for fatigue based on infinite life. If the life is not infinite, estimate the number of cycles. Be sure to check for yielding. Round the answers to two decimal places.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?

Answers: 1

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

Engineering, 06.07.2019 04:20

Two microscope slides are placed horizontally, one on top of the other, with a drop of a dishwashing liquid between them. the gap between the slides is 1 mm. a machine pulls the top slide to the right with a velocity of 0.15 millimeters per second while the bottom slide is held stationary. a stress gage indicates that a shearing stress of 0.5 pa is required to pull the top slide with this velocity. if the dishwashing liquid adheres to both slides during this process, what is the viscosity of the liquid? specify whether your answer is dynamic or kinematic viscosity, and use appropriate units.

Answers: 1

Answer

You know the right answer?

A part is loaded with a combination of bending, axial and torsion such that the following stresses a...

Questions