subject
Engineering, 17.04.2020 00:03 BlueExorcistReaper

An air conditioner must maintain a computer laboratory at 18°C when the outside temperature is 30°C. The thermal load that must be removed from the room consists of heat transfers entering through the walls and roof of the laboratory at a rate of 75,000 kJ/h and from the computers, lighting, and occupants at a rate of 15,000 kJ/h. (a) Determine the maximum theoretical coefficient of performance and the corresponding minimum theoretical power required by the air conditioner, in kW (Ans: COPR, max = 24.25; W min = 1.03 kW;) (b) If the actual power required by the air conditioner for this duty is 8.3 kW, determine the coefficient of performance. (Ans: COPR = 3.01) (c) If the given temperature and thermal load are observed for a total of 100 hours and electricity costs are 13 cents per kW-h, determine the cost, in $, over that period for each of cases (a) and (b). (Ans: case (a), cost = $ 13.4; case (b), cost = $ 107.9)

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
question
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
question
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
question
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
You know the right answer?
An air conditioner must maintain a computer laboratory at 18°C when the outside temperature is 30°C....
Questions