Engineering, 16.04.2020 02:01 deanblackstone

Design a posttest-only experiment that would test each of the following causal claims. For each one, identify the study’s independent variable(s), identify its dependent variable(s), and suggest some important control variables. For each study, determine a survey that you might administer that would give the research additional information on individual personality differences. a. Students given negative (versus positive) feedback on an important value they possess causes individuals to act more aggressively. b. Exercising for 30 minutes a day (compared with 10 minutes a day) causes less depression. c. Exposing individuals to messages that ones peers engage in environmental friendly behaviors (versus receiving an informational flyer about the importance of the environment) leads to increases in environmental friendly behaviors.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

Answer

You know the right answer?

Design a posttest-only experiment that would test each of the following causal claims. For each one,...

Questions