Cameron is measuring a feature that has a tolerance of ±0.003in.
What bilateral tolerance sho...
Engineering, 24.03.2020 18:49 QueenMiah16
Cameron is measuring a feature that has a tolerance of ±0.003in.
What bilateral tolerance should Cameron apply to the working gage if the master gage used to set the working gage has a bilateral tolerance of ±0.00003in?
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 18:10
The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false
Answers: 1
You know the right answer?
Questions
Chemistry, 13.06.2020 18:57
Mathematics, 13.06.2020 18:57
Social Studies, 13.06.2020 18:57
Mathematics, 13.06.2020 18:57
Mathematics, 13.06.2020 18:57
Business, 13.06.2020 18:57
