Engineering, 05.03.2020 23:20 live4dramaoy0yf9

Consider a subsonic engine inlet (i. e., a diffuser) with an inlet area of 1.5 m² and exit-to-inlet area ratio of 1.44. Air enters the diffuser flowing at 5 kg/s with a static pressure of 0.350 bar and a velocity of 110 m/s. The gases exit the diffuser at a static pressure of 0.375 bar and a velocity of 80 m/s. Assume that the ambient (external) pressure on the walls of the diffuser is 0.340 bar.
(a) For these conditions, what is the force (in units of lbf and N) transmitted to the structure holding the diffuser? Provide both the direction and magnitude of the force and use a picture to help present your answer.
(b) Based solely on your results, comment on whether the force acting on the diffuser would help speed up or slow down a vehicle that used this diffuser as part of a jet propulsion system.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

Answer

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

You know the right answer?

Consider a subsonic engine inlet (i. e., a diffuser) with an inlet area of 1.5 m² and exit-to-inlet...

Questions