Engineering, 27.12.2019 07:31 tsbrunson13

The composition of the feed to a debutaniser is given below. make a preliminary design for a column to recover 98 per cent of the n-butane overhead and 95 per cent of the isopentane from the column base. the column will operate at 14 bar and the feed will be at its boiling point. use the short-cut methods and follow the procedure set out below. use the de priester charts to determine the relative volatility. the liquid viscosity can be estimated using the data given in appendix d.
(a) investigate the effect of reﬂux ratio on the number of theoretical stages. (b) select the optimum reﬂux ratio. (c) determine the number of stages at this reﬂux ratio. (d) estimate the stage efﬁciency. (e) determine the number of real stages. (f) estimate the feed point. (g) estimate the column diameter.

feed composition (kg/h):
propane c3 (910 kg/h)
isobutane i-c4 (180 kg/h)
n-butane n-c4 (270 kg/h)
isopentane i-c5 (70 kg/h)
normal pentane n-c5 (90 kg/h)
normal hexane n-c6 (20 kg/h)

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Aseries piping system conveys methyl alcohol. the system consists of 70 m of 1- nominal pipe follow by 50 m of 2-nominal pipe, both schedule 40 commercial steel. the 1-nominal pipe contains 3 90° elbows (regular) anda fully open gate valve, all threaded. the pressure drop through the system is 150 kpa. determine the volume flow rate through the system that is horizontally laid.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.

Answers: 1

Answer

You know the right answer?

The composition of the feed to a debutaniser is given below. make a preliminary design for a column...

Questions