Engineering, 18.12.2019 04:31 heyhay5748
For a bolted assembly with six bolts, the stiffness of each bolt is kb 5 3 mlbf/in and the stiffnessof the members is km 5 12 mlbf/in per bolt. an external load of 80 kips is applied to theentire joint.
assume the load is equally distributed to all the bolts. it has been determined touse 12 in-13 unc grade 8 bolts with rolled threads.
assume the bolts are preloaded to 75 percentof the proof load.
(a) determine the yielding factor of safety.
(b) determine the overload factor of safety.
(c) determine the factor of safety based on joint separation
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.
Answers: 1
Engineering, 04.07.2019 18:20
Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]
Answers: 1
You know the right answer?
For a bolted assembly with six bolts, the stiffness of each bolt is kb 5 3 mlbf/in and the stiffness...
Questions
Arts, 19.10.2019 02:30
Biology, 19.10.2019 02:30
Spanish, 19.10.2019 02:30
Spanish, 19.10.2019 02:30
Mathematics, 19.10.2019 02:30
History, 19.10.2019 02:30
Mathematics, 19.10.2019 02:30
Mathematics, 19.10.2019 02:30
