subject
Engineering, 17.12.2019 01:31 NotAPDB1441

From the niebel's methods, standards, and work design 13th editon textbook chapter #14 problem #1:

1.) the analyst in the dorben reference library decides to use the work sampling technique to establish standards. twenty employees are involved. the operations include cataloging, charging books out , returning books to their proper location, cleaning books, record keeping, packing books for shipment, and handling correspondence. a preliminary investigation resulted in the estimate that 30 percent of the group's time was spent in cataloging. how many work sampling observations would be made if it were desirable to be 95 percent confident that the observed data were within a tolerance of +/- 10 percent of the population data? describe how the random observations should be made. the following table illustrates some of the data gathered from 6 of the 20 employees. the number of volumes cataloged equals 14,612. from these data, determine standard, in hours per hundred, for cataloging. then design a control chart based on +/- 3 sigma limits for the daily observations. operators

item smith apple brown green baird thomas

total hours worked 78 80 80 65 72 75
total observations (all elements) 152 170 181 114 143 158
observations involving cataloging 50 55 48 29 40 45
average rating 90 95 105 85 90 100

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 18:10
Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed.gi) ifn 1, what will happen to the material when transformed material when
Answers: 1
You know the right answer?
From the niebel's methods, standards, and work design 13th editon textbook chapter #14 problem #1: <...
Questions
question
Mathematics, 26.06.2019 23:00