Engineering, 17.12.2019 01:31 ashlynmartinezoz2eys
Acontinuous and aligned fiber reinforced composite having a cross-sectional area of 1130 mm 2 (1.75 in. 2 ) is subjected to an external tensile load.
if the stresses sustained by the fiber and matrix phases are 156 mpa (22,600 psi) and 2.75 mpa (400 psi), respectively, the force sustained by the fiber phase is 74,000 n (16,600 lb f ), and the total longitudinal strain is 1.25x10 −3, determine the following: (a) the force sustained by the matrix phase(b) the modulus of elasticity of the composite material in the longitudinal direction(c) the moduli of elasticity for fiber and matrix phases
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
Engineering, 06.07.2019 02:30
An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?
Answers: 3
Engineering, 06.07.2019 02:30
On solidification from a melt, the polymer polyethylene forms a semi-crystalline spherulite structure. (i) sketch an individual spherulite and label the amorphous and crystalline regions. (ii) draw a schematic to show the changes in specific volume with temperature during cooling from the melt, comparing it to the theoretical extremes of fully crystalline and fully amorphous (indicate tm and tg)
Answers: 2
You know the right answer?
Acontinuous and aligned fiber reinforced composite having a cross-sectional area of 1130 mm 2 (1.75...
Questions
Mathematics, 26.07.2019 16:00
Mathematics, 26.07.2019 16:00
Mathematics, 26.07.2019 16:00
English, 26.07.2019 16:00
Chemistry, 26.07.2019 16:00
