Engineering, 06.12.2019 04:31 kayranicole1

Abuilding with the characteristics listed is located below where the annual heating season lasts 21 weeks. the inside design temperature is 70°f . the average outside air temperature is 30°f. the gas furnace has an efficiency of 75% . fuel costs $0.25 per therm. the building is occupied only from 8 a. m. until 6 p. m., monday through friday. in the past, the building was maintained 70°f at all times and ventilated with one air change per hour (based on inside conditions). the thermostat is now being set back 12°f and the ventilation reduced 50% during the unoccupied times. infiltration through cracks and humidity changes are disregarded . what is the annual savings? data;

internal volume: 801,000 ft3
wall area: 11,040 ft2
wall overall heat transfer coefficient: 0.15 btu/ ft2 -hr-°f
window area: 2760 ft2
window overall heat transfer coefficient: 1.13 btu/ft2 -hr-°f
roof area: 26,700 ft2
roof overall heat transfer coefficient: 0.05 btu/ft2 -hr-°f
slab on grade: 690 lineal ft of exposed slab edge
slab edge coefficient: 1.5 btu/ft-hr-°f

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Ashielded metal arc-welding operation is accomplished in a work cell by a fitter and a welder. the fitter takes 5.5 min to load components into the welding fixture at the beginning of the work cycle, and 1.5 min to unload the completed weldment at the end of the cycle. the total ength of the weld seams 1200 mm, and the travel speed used by the welder averages 300 mm/min. every 600 mm of seam length, the welding stick must be changed, which takes 0.8 min. while the fitter is working, the welder is idle (resting): and while the welder is working the fitter is idle. (a) determine the average arc-on time as a fraction of the work cycle time. (b) how much improvement in arc-on time would result if the welder used flux-cored arc welding (manually operated), given that the spool of weld wire must be changed every 10 weldments, and it takes the welder 5.0 min to accomplish the change? (c) what are the production rates for these two cases (weldments completed per hour)? attach your work and solutions.

Answers: 1

Answer

You know the right answer?

Abuilding with the characteristics listed is located below where the annual heating season lasts 21...

Questions