Engineering, 05.12.2019 04:31 Pfaith8617

Along, cylindrical electrical heating element of diameter d= 10 mm, length l= 0.25 m, thermal conductivity k = 240 w/m-k, density rho= 2700 kg/m3, and the specific heat c p=900 j/kg-k. the heater element is installed in a duct in which the air is flowing at a velocity of 10 m/s, and at an air temperature of 27oc. and 10 m/s, respectively. neglecting radiation, the steady state surface temperature of the rod is 3300c. a) what is the averaged heat convecition h ? b) determine per unit length of the heater, electrical energy is being dissipation rate. c) if the heater is activated from an initial temperature of 500c, estimate the time required for the surface temperature to come to 100c of its steady-state value.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

Answer

You know the right answer?

Along, cylindrical electrical heating element of diameter d= 10 mm, length l= 0.25 m, thermal conduc...

Questions