subject
Engineering, 25.11.2019 22:31 joyelewis58

Write a matlab program that calculates the arithmetic mean, the geometric mean, and the root-mean-square average for a given set of values. your program must use 3 functions to calculate the 3 required means. the output should be formatted as follows:

your name statistical package arithmetic mean = x. geometric mean = x. rms average = x.

test your program on the following values: 1.1, 3.3, 3.00, 2.22, 2.00, 2.72, 4.00, 4.62 and 5.37. your main program calls 3 functions.

the data should be read by the main program from a text file, stored in an array and then passed to the functions.

the results and any other output should be printed by the main program. notice how the output results are aligned. also notice that the results are printed accurate to 5 decimal places.

do not use matlab built-in functions.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
question
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
question
Engineering, 04.07.2019 18:10
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
question
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
You know the right answer?
Write a matlab program that calculates the arithmetic mean, the geometric mean, and the root-mean-sq...
Questions
question
Mathematics, 31.08.2021 01:00
question
Mathematics, 31.08.2021 01:00
question
Mathematics, 31.08.2021 01:00
question
English, 31.08.2021 01:00