subject
Engineering, 13.11.2019 20:31 yvngtazz

An inexpensive food and beverage container is fabricated from 25-mni-thick polystyrene (k = 0.023 w/m k) and has interior dimensions of 0.8 m times 0.6 m times 0.6 m. under conditions for which an inner surface temperature of approximately 2 degree c is maintained by an ice-water mixture and an outer surface temperature of 20 degree c is maintained by the ambient, what is the heat flux through the container wall? assuming negligible heat gain through the 0.8 m times 0.6 m base of the cooler, what is the total heal load for the prescribed conditions?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 19:20
Determine the stoichiometric and actual air-fuel ratios and the mole flue gas composition for combustion with 15% excess air for raw indiana, pennsylvania raw coal.
Answers: 3
question
Engineering, 04.07.2019 19:20
Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?
Answers: 2
question
Engineering, 06.07.2019 03:10
Air is flows through an adiabatic nozzle with an inlet pressure of 400 psia at a temperature of 300°f and a velocity of 20 ft/s. the outlet pressure is 40 psia and the velocity is 800 ftl/s. determine the outlet temperature of the air using: a) property tables b) specific heat (using the specific heat value for air at 300°f)
Answers: 3
question
Engineering, 06.07.2019 04:10
Steam enters a converging nozzle at 3.0 mpa and 500°c with a negligible velocity, and it exits at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: is isentropic (a) (b) has an efficiency of 94 percent
Answers: 1
You know the right answer?
An inexpensive food and beverage container is fabricated from 25-mni-thick polystyrene (k = 0.023 w/...
Questions
question
English, 22.06.2019 23:00