subject
Engineering, 09.11.2019 03:31 ZacharyGallagher

The human circulatory system consists of a complex branching pipe network ranging in diameter from
the aorta (largest) to the capillaries (smallest). the average diameter and the number of these vessels are
shown in the table. does the average blood velocity increase, decrease, or remain constant as it travels
from the aorta to the capillaries?

vesselaverage diameter [mm]number
aorta25.01
arteries4.0159
arterioles0.061.4*10^7
capillaries0.0122.9*10^9
this is an excercise that requires application of conservation of mass.

all the "m" are mass flow rate, p is density, n is number of vessels, a is area

m [kg/s]=m_aorta=m_arteries=n*p*v_avg *a_vessel

v(volume flow rate) [m^3/s]=m/p=v_avg*a

blood can be considered incompressible; that is, the density does not change as the blood moves from large vessesl to small vessels. assume the density of blood is equal to 1060 kg/m^3.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs
Answers: 2
question
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
question
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
You know the right answer?
The human circulatory system consists of a complex branching pipe network ranging in diameter from
Questions
question
Chemistry, 11.05.2021 20:50
question
Mathematics, 11.05.2021 20:50
question
Biology, 11.05.2021 21:00