Engineering, 05.11.2019 22:31 KarrieShea42
A10 cm x 10 cm circuit board dissipating 10 w of power uniformly is cooled by air, which approaches the circuit board at 15°c with a velocity of 4 m/s. disregarding any heat transfer from the back surface of the board, determine the surface temperature of the electronic components at the end of the board. determine the surface temperature of the electronic components (a) at the leading edge and (b) at the end of the board. assume the flow to be turbulent since the electronic components are expected to act as turbulators. assume a film temperature of 27°c.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
Engineering, 04.07.2019 18:20
Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?
Answers: 1
Engineering, 04.07.2019 18:20
Water vapor initially at 10 bar and 400 °c is contained within a piston-cylinder assembly. the water lost heat to the surrounding according to isochoric (iso-volumetric) process until its temperature is 150 °c. the water is then condensed isothermally to saturated liquid. for the water as a system, calculate the work in kj/kg
Answers: 2
Engineering, 04.07.2019 19:20
Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?
Answers: 2
You know the right answer?
A10 cm x 10 cm circuit board dissipating 10 w of power uniformly is cooled by air, which approaches...
Questions
History, 18.10.2019 20:30
Mathematics, 18.10.2019 20:30
Social Studies, 18.10.2019 20:30
Mathematics, 18.10.2019 20:30
English, 18.10.2019 20:30
English, 18.10.2019 20:30
Geography, 18.10.2019 20:30
