Engineering, 31.10.2019 00:31 b2cutie456

On january 9, 2014, 10,000 gallons of crude mchm (75% pure, density=0.9074 g/cm3) was spilled into the elk river in wv, which is tributary to the ohio river (assume the spill occurred instantaneously). estimate the mchm concentration profile at the greater cincinnati water works intake 310 km downriver. the river had a flow of q=3,350 m3/s during the spill, the average river width is 400 m, average depth is 14 m, the average slope is 8x10-5 m/m and a rectangular cross section can be assumed. assume mchm is conservative (not reactive) in this environment. how does the mchm concentration profile you calculate compare to the actual concentration of about 20?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj

Answers: 2

Answer

You know the right answer?

On january 9, 2014, 10,000 gallons of crude mchm (75% pure, density=0.9074 g/cm3) was spilled into t...

Questions