Engineering, 09.10.2019 03:20 pindu

A10-in-thick., 30-ft-long, and 10-ft-high wall is to be constructed using 9-in-long solid bricks (k = 0.40 btu/h·ft·°f) of cross section 7 in × 7 in, or identical size bricks withnine square air holes (k = 0.015 btu/h·ft·°f) that are 9 inlong and have a cross section of 1.5 in× 1.5 in . there isa 0.5- in-thick plaster layer (k = 0.10 btu/h·ft·°f) between twoadjacent bricks on all four sides and on both sides of the wall. the house is maintained at 80°f and the ambient temperature outside is35°f. taking the heat transfer coefficients at the inner andouter surfaces of the wall to be 1.5 and 6 btu/h·ft2·°f. respectively, determine the rate of heat transfer through the wall constructed of(a) solid bricks and (b) bricks with air holes.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 19:30

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

Answer

You know the right answer?

A10-in-thick., 30-ft-long, and 10-ft-high wall is to be constructed using 9-in-long solid bricks (k...

Questions