subject
Engineering, 29.09.2019 02:30 erstaabi000

Eight pv modules are available, each module has the characteristics of problem 1 above at standard conditions of 1000 w/m^2 and 25°c. at these conditions, what is the best series/parallel connection of the eight pv modules to maximize power delivered to a resistive load of: a) 6 ohms and b) 12 ohms? for your optimum configurations, what powers are delivered?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 06.07.2019 03:20
What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.
Answers: 3
question
Engineering, 06.07.2019 04:30
Calculate the equilibrium concentration of vacancies per cubic meter in pure aluminum at 500°c. assume that the energy of formation of a vacancy in pure aluminum is 0.76 ev. what is the vacancy fraction at 650°c.
Answers: 3
question
Engineering, 06.07.2019 05:10
Comment on the effect of lubrication of the punch surfaces on the limiting drawing ratio in deep drawing.
Answers: 3
question
Engineering, 06.07.2019 05:20
A200-mm wide strip 25 mm thick is fed through a rolling mill w/two powered rolls each of radius = 250 mm. the work thickness is to be reduced to 22 mm in one pass at a roll speed of 60 rev/min. the average flow stress of the work material, as it passes through the rolls is 175 mpa. the friction coefficient between rolls and work material is 0.20. 1, determine a)-if friction is sufficient for rolling.b)- if friction is sufficient: c)- calculate roll force i calculate roll torque. d)- calculate roll power.
Answers: 2
You know the right answer?
Eight pv modules are available, each module has the characteristics of problem 1 above at standard c...
Questions