subject
Engineering, 29.09.2019 02:30 shealwaysknows23

Atank of constant volume 50 m^3 initialy containing air at temp 10c and at pressure 253 kpa was being charged wit air at 5c by a compressor until the pressure was equal to 2.8 mpa. the work needed to compressed air was 35mj. during the process 25mj of heat flowed away frinm the tank to the atmosphere. assuming air to be ideal, diatomic gas of individual gas constant equal to 287 j/kgk. find the amount of air transferred to the tank and the final temp. of the tank. cv = 1/(k-1)r, cp = k/(k-1)r and k=1.4.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?
Answers: 1
question
Engineering, 04.07.2019 18:10
Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?
Answers: 2
question
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
You know the right answer?
Atank of constant volume 50 m^3 initialy containing air at temp 10c and at pressure 253 kpa was bein...
Questions
question
Mathematics, 30.01.2022 14:00
question
English, 30.01.2022 14:00
question
Mathematics, 30.01.2022 14:00