Engineering, 13.09.2019 23:30 isaiahb30
Calculate the actual positional tolerance in the following scenario: 12mm hole (n) measures 12.2 mm (assume +/- .2 dimensional tolerance)
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:10
Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.
Answers: 1
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
You know the right answer?
Calculate the actual positional tolerance in the following scenario: 12mm hole (n) measures 12.2 mm...
Questions
Social Studies, 06.07.2019 23:30
Social Studies, 06.07.2019 23:30
Mathematics, 06.07.2019 23:30
Mathematics, 06.07.2019 23:30
Mathematics, 06.07.2019 23:30
Mathematics, 06.07.2019 23:30
Biology, 06.07.2019 23:30
English, 06.07.2019 23:30
History, 06.07.2019 23:30
English, 06.07.2019 23:30
Health, 06.07.2019 23:30
History, 06.07.2019 23:30
