Engineering, 17.07.2019 23:40 missyli400

An adiabatic heat exchanger is used to heat cold water at 15°c entering at a rate of 5 kg/s by hot air at 77°c entering at a rate of 3 kg/s. the exit temperature of the hot air is 25°c. deterimine the exit temperature (°c) of the cold water.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

Answer

Engineering, 04.07.2019 18:20

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

What are the major differences between injection molding and extrusion?

Answers: 2

Answer

You know the right answer?

An adiabatic heat exchanger is used to heat cold water at 15°c entering at a rate of 5 kg/s by hot a...

Questions