Why isn't 802.1x a good choice for home based wireless networks

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."

How can the temperature of a room be raised by 5degreesf?

In a heat transfer course, we can derive the equation for the temperature distribution in a flat rectangular plate. in this example, we will look at a plate at steadystate with three sides being held at t1, and one side held at t2. the temperature for any location on the plate, t(x,y), can be calculated by where create a function (prob3_5) that will take inputs of vectors x and y in feet, scalar n, scalars l and w in feet and scalars t1 and t2 in degrees fahrenheit. it will output a matrix t which is the temperature of each x and y locations. t will have the number of columns equal to the number of elements in x and rows equal to the number of elements in y. though this can be done without loops (perhaps more efficiently), your program must use a nested loop.