Computers and Technology, 13.04.2021 17:20 heyyyyy3922

if you have anything you want to talk about (either its venting- ranting, or you just need some advice/help) go ahead and say it here :) I'll listen

Answers: 2

Show answers

Another question on Computers and Technology

Computers and Technology, 22.06.2019 07:00

Robots with telescoping arms are sometimes used to perform tasks (e.g., welding or placing screws) where access may be difficult for other robotic types. during a test run, a robot arm is programmed to extend according to the relationship r = 3 + 0.5cos(4θ) and the arm rotates according to the relationship θ=−π4t2+πt , where r is in feet, θ is in radians, and t is in seconds. use a computer program to plot the path of tip a in x and y coordinates for 0 ≤ t ≤ 4s.

Answers: 2

Answer

Computers and Technology, 22.06.2019 14:50

Drag each label to the correct location on the image list the do’s and don’ts of safeguarding your password. a. keep yourself logged in when you leave your computer.b. don’t write your password down and leave it where others can find it.c. share your password with your friends.d.each time you visit a website,retain the cookies on your computer.e. use a long password with mixed characters.1. do's 2. don'ts

Answers: 2

Answer

Computers and Technology, 23.06.2019 05:00

Acompany is inviting design for its new corporate logo from its users. this is an example of ? a. crowdfunding b. crowdvoting c. crowdsourced design d. crowdtracking

Answers: 3

Answer

Computers and Technology, 23.06.2019 15:30

Write a program in plp assembly that counts up by one starting from zero (or one) inside a loop and writes this value to the leds every time the value is increased. the memory address of the leds is 0xf0200000. the table below shows the meaning and an example usage of the instructions covered in the video, plp instructions for project 1. instruction example usage meaning load immediate li $t0, 8 register $t0 is set to the value, 8. store word sw $t2, 0($t1) the value in register $t1 is used as the memory address. the value in register $t2 is copied into this memory address. add addiu $t4, $t3, 29 register $t4 is assigned the sum of 29 and the value in register $t3. jump j your_label_name the program jumps to the line following the label, "your_label_name: ". label your label name: defines a label called "your_label_name: " that can be jumped to

Answers: 2

Answer

You know the right answer?

if you have anything you want to talk about (either its venting- ranting, or you just need some advi...

Questions