Computers and Technology, 25.07.2019 06:10 dacey4164
Write a c program that generates a tune with 10 different pitches, gradually altered from high to low. a delay of approximately halfsecond should be there between each pitch of tune. program shouldterminate whenever any key is pressed.
Answers: 3
Computers and Technology, 22.06.2019 03:30
Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault Õ figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo.i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.
Answers: 2
Computers and Technology, 22.06.2019 16:20
Consider the following statements, then select one of the answers below: the signal() function shown below registers "sig_handler()" as the signal handler function for the sigkill signal, without the complexity of using when the sigkill signal is sent to a process running this code, by a user typing "kill -kill ", where the correct process id is used for to target the process, sig_handler() will be executed.
Answers: 1
Computers and Technology, 23.06.2019 00:30
Which of the following would you find on a network
Answers: 3
Computers and Technology, 23.06.2019 03:30
Hashtags serve to identify the topic of a given tweet true false
Answers: 2
Write a c program that generates a tune with 10 different pitches, gradually altered from high to lo...
History, 27.09.2021 22:30
Health, 27.09.2021 22:30
Mathematics, 27.09.2021 22:30
Physics, 27.09.2021 22:30
Social Studies, 27.09.2021 22:30
Biology, 27.09.2021 22:30
History, 27.09.2021 22:30
Mathematics, 27.09.2021 22:30
English, 27.09.2021 22:30
Chemistry, 27.09.2021 22:30
Biology, 27.09.2021 22:30