Read each statement below. if the statement describes a peer-to-peer network, put a p next to it. if the statement describes a server-based network, put an s next to it. p - peer-to-peer s - server-based 1. passwords are required to log in to the network 2. provides centralized network security 3. relatively low cost 4. scalable 5. used in organizations with lots of employees

How can i delete permalinks from a word press site?

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."

1. which of these is not true about torsion bars? a. they can be used to adjust ride height b. they can be adjusted anytime since they don't affect alignment angles c. they attach between the frame and the lower control arm d. they twist to produce a spring effect