Only 5 questions 1.which answer represents a speed, not a velocity? a. 35 m/s east b. –35 m/s down c. 35 m/s d. 35 m/s south 2.a car traveled at an average speed of 60 mph for two hours. how far did the car travel? a. 30 miles b. 60 miles c. 120 miles d. 150 miles 3.a car goes from point a to point b then back again. which statement about its speed and velocity is true? a. they are the same. b. the velocity is twice the speed. c. the speed is twice the velocity. d. the velocity is zero but the speed is positive. 4.a car goes from point a to point b, five miles away and then returns to point a. the car is going 15 mph. what is the velocity of the car? a. –30 mph b. 0 mph c. +15 mph d. +45 mph 5.a cyclist rode at an average speed of 15 mph for 30 miles. how long was the ride? a. 0.5 hours b. 1 hour c. 2 hours d. 3 hours

1. c

2. c

3. d

4. b

5. c

i just took the test and got them all right

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

neither accurate nor precise.