Physics, 20.07.2019 14:40 kiylabeasty7302

Which of theses statements are true about the theory of plate tectonics and the theory of continental drift a) the theory of plate tectonics doesn't explain how continental movements could occur b) the theory of tectonics tells exactly where the continents were before pangaea divided c) the theory of plate tectonics proves the theory of continental drift completely wrong d) the theory of plate tectonics gives the method by which continents can move as part of plates

Answers: 2

Show answers

Another question on Physics

Physics, 21.06.2019 15:30

Which of the following statements are true of solids? a.the particles do not vibrate. b.the particles are in a fixed location. c.they have strong intermolecular forces between the atoms or molecules. d.the particles have less kinetic energy than those of liquids or gases.

Answers: 1

Answer

Physics, 22.06.2019 00:30

Imagine you work as a consultant, and your daily job involves listening to the constructive criticism of others. as part of your job, you must listen to opposing viewpoints to make important decisions. in this activity, you are a consulting dam engineer. you must make a decision about four different dams; should they be repaired, taken down, or left alone? you will listen to contrasting opinions about what should be done with the dams before you make the final decision. as the consulting dam engineer, what do you decide to do with this dam? explain your reasoning. by making your decision, did you support the opinions of the mayor and/or the dam safety official? why or why not? (site 1)

Answers: 1

Answer

Physics, 22.06.2019 21:30

Ineed this now one scientist feels that the changes in global climatic patterns may be good for the health of the biosphere. another scientist feels that sharp changes in climatic patterns could result in the extinction of the biosphere. which of these is the most likely reason the two scientists gave conflicting opinions on the impact of changes in the global climatic pattern? they do not have enough knowledge on the topic. they did not discuss the issue among themselves. they believe conflicting opinion strengthens science. they study different areas of science and have different scientific focuses.

Answers: 1

Answer

Physics, 23.06.2019 08:30

Atension test was conducted on a specimen of aisi 1020 hot-rolled steel having an initialdiameter of 9.11 mm. representative test data are given in table1in the form of force and engineering strain. for strain the extensometer gage length was li= 50.8 mm. in addition, minimumdiameters were measuredmanually with a micrometer in the necked region at several points during the test. after fracture, thebroken halves were reassembled, and the following measurements were made: (1) marks originally 25.4 mm apart and on opposite sides of the necked regionwere 38.6 mm apart due to the lengthwise stretching in the specimen; (2) similar marks originally 50.8 mm apart were 70.9 mmapart; (3) the final minimum diameter in the necked region was 5.28 mma) determine the following material properties: elastic modulus, 0.2% offset yield strength, ultimate tensile strength, percent elongation, and percent reduction in area. b) assume that the test was interrupted upon reaching a strain u = 0.007, and the specimen unloaded to zero force. estimate the elastic strain recovered and the plastic strain remaining. also, what would the new length of the original 50.8 mm gage section. hint: might save time/effort to use excel, mathcad, matlab, etc. to solve part a)table1 data and analysis for a tension test on aisi 1020 hot-rolled steeltest dataforce (p, kn)1. 0.002. 6.673. 13.344. 19.135. 17.796. 17.217. 17.538. 17.449. 17.2110. 20.7711. 24.2512. 25.7113. 25.7514. 25.0415. 23.4916. 21.3517. 18.9018. 17.39engr. strain (ε)1. 02. 0.00053. 0.00104. 0.00155. 0.00236. 0.00317. 0.00508. 0.00709. 0.010010. 0.049011. 0.125012. 0.218013. 0.234014. 0.306015. 0.330016. 0.348017. 0.360018. 03660diameter (d, mm)1. 9.112. 9.113. 9.114. 9.115. 9.116. 9.117. 9.118. 9.119. 9.1110. 8.8911. 8.8912. 8.2613. 8.2614. 7.6215. 6.9916. 6.3517. 5.7218. 5.28

Answers: 2

Answer

You know the right answer?

Which of theses statements are true about the theory of plate tectonics and the theory of continenta...

Questions