Physics, 19.07.2019 23:00 ciarakelly636owuiup

Ascientist designs an experiment in which a light source is pointed at a substance and a light detector is placed on the opposite side of the substance. when the light source is turned on, the scientist observes that no light is detected on the far side of the substance. what is the best interpretation for this observation? a. the light was either reflected or transmitted by the substance. b. the light was both absorbed and reflected by the substance. c. the light was both reflected and transmitted by the substance. d. the light was either absorbed or reflected by the substance.

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 19:30

Molten iron fills a mould, which has a volume of 200 cm cubed. calculate the volume when the iron cools and solidifies. molten iron has a density of 7.0g/cm cubed. in its solid state, iron has a density of 8.0g/cm cubed.

Answers: 3

Answer

Physics, 22.06.2019 11:30

With the simplified model of the eye, what corrective lens (specified by focal length as measured in air) would be needed to enable a person underwater to focus an infinitely distant object? (be careful-the focal length of a lens underwater is not the same as in air! assume that the corrective lens has a refractive index of 1.62 and that the lens is used in eyeglasses, not goggles, so there is water on both sides of the lens. assume that the eyeglasses are 1.90

Answers: 1

Answer

Physics, 22.06.2019 13:00

The magnitude of the amount of energy released by burning a fuel source, measured in energy per unit mass, is called its fuel value. note that the fuel value is the negative of the isobaric specific heat of combustion for the fuel. if all the energy obtained from burning 1.23 pounds of butane with a fuel value of 10.85 kcal/g is used to heat 128.0 kg of water at an initial temperature of 18.3 °c, what is the final temperature? note that 1 lb = 453.6 g.

Answers: 3

Answer

Physics, 22.06.2019 15:00

10 points! will mark brainiest! in a heat engine if 1,000 j of heat enters the system and the piston does 500 j of work, what is the final internal energy of the system if the initial energy was 2,000 j 1: write the equation 2: list out your known variables 3: plug the numbers into the equations 4: solve 5: write your solution statement that includes initial energy and final energy added you so much!

Answers: 3

Answer

You know the right answer?

Ascientist designs an experiment in which a light source is pointed at a substance and a light detec...

Questions